Home › Forums › Wireless Kits Support (KIT-1, KIT-2, TX134 etc) › Use for door latch or electric door strike
This topic contains 3 replies, has 3 voices, and was last updated by William 2 months ago.
What would be the recommended configuration for a door latch or electric door strike.
For the wiring part, typical door latch is just a simple on/off control, so refer to following wiring.
It is just the same as our led strip application, belowhttps://imgur.com/a/oMZQYDX
The only difference is, replace led strip in wiring photo with your lock.—
For working mode, you might choose either hold (on/off) or timed output (auto release/lock after certain period).
Thank you. It works perfectly.
The end user wants a 6-8 seconds after the button is pressed instead of holding the button. What are the instructions for that?
Thanks for the help.
See below for timer mode video, thanks.
Mail (will not be published) (required):
Notify me of follow-up replies via email
Enter the destination URL
Or link to existing content