[Resolved] Use for door latch or electric door strike

Home Forums Wireless Kits Support (KIT-1, KIT-2, TX134 etc) Use for door latch or electric door strike

This topic contains 3 replies, has 3 voices, and was last updated by   William 2 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #13685 Reply

    Steven Jablonski

    What would be the recommended configuration for a door latch or electric door strike.

    Thanks

    #13693 Reply

    William
    Keymaster

    For the wiring part, typical door latch is just a simple on/off control, so refer to following wiring.

    It is just the same as our led strip application, below
    https://imgur.com/a/oMZQYDX

    The only difference is, replace led strip in wiring photo with your lock.

    For working mode, you might choose either hold (on/off) or timed output (auto release/lock after certain period).

    #13868 Reply

    sjablonski
    Participant

    Thank you. It works perfectly.

    The end user wants a 6-8 seconds after the button is pressed instead of holding the button. What are the instructions for that?

    Thanks for the help.

    #13871 Reply

    William
    Keymaster
Viewing 4 posts - 1 through 4 (of 4 total)
Reply To: Use for door latch or electric door strike
Your information: