[Resolved] Storing Transmitter Codes

Home Forums Wireless Kits Support (KIT-1, KIT-2, TX134 etc) Storing Transmitter Codes

This topic contains 1 reply, has 2 voices, and was last updated by   William 2 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #13027 Reply


    I am using the Solidremote 202U to open my old garage door opener. I set it up exactly like the solution in the topic above “How to set up the KIT-1 as a garage door receiver”. When I go to program the remotes, the Signal LED is constantly illuminated…even without pressing PRG1 or PRG2. So needles to say, it’s not programming the receivers at all. Could there be an issue with the unit? I’ve tried using both relays but I keep getting the same results. Any idea?


    #13028 Reply


    SIG led should be off initially when receiver powered up.
    If it is constantly on, it could be defective.

    First try power up our receiver using a different power supply, such as standard 12vdc power adapter (since sometimes power cause weird problem).
    If it still shows same behaviour, return it for full refund.

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Storing Transmitter Codes

You can use BBCodes to format your content.
Your account can't use Advanced BBCodes, they will be stripped before saving.

Your information: