[Resolved] reversing dc motor

This topic contains 2 replies, has 2 voices, and was last updated by   William 7 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #13017 Reply

    brad sletten

    I have a 12 volt dc motor wired thru a dpdt switch that does what it is suppose to do. I would like to connect my kit-1 to my terminal strip so that it does the same thing. what dip switch setting do I use and what connections on your terminal strip do I use? the dc motor is double gear reduction so I’m hoping amperage is not a problem. max amperage?

    #13019 Reply

    Mel

    I think I have the same/similar question. Have a 2 wire DC motor and I want it normally off, button one energize lead one and ground lead two. Remote button two connects motor backwards.

    How? Thanks

    #13021 Reply

    William
    Keymaster

    To make 202U relays directly control DC motors.
    Please make sure the motor rating is less than 12Vdc, 6A.

    Does your motor meet above requirements?

Viewing 3 posts - 1 through 3 (of 3 total)
Reply To: reversing dc motor
Your information: