[Resolved] Reversing boat lift motor

Home Forums Wireless Kits Support (KIT-1, KIT-2, TX134 etc) Reversing boat lift motor

This topic contains 1 reply, has 2 voices, and was last updated by   William 4 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #12964 Reply

    David

    I need to set up my remotes to make a boat lift go up or down. I have two separate relays to control the ac motor direction. Button A activates the up relay. Button B activates the down relay. Is there a way to use interlocking latching mode that would require a stop before changing directions? I do not want to be able to go directly from one direction to the other as it could damage the motor.

    #12965 Reply

    William
    Keymaster

    Hello David,
    Sorry but the ‘stop’ function is not available on our receiver.
    Also wire directly relay to motor would damage our relay pretty quickly (because the boat lift will likely exceed our relay ratings, 6A @ 14Vdc for motor load).
    I would suggest you just use our wireless function, and wire our relay to your main controller board (where you have bigger relays & more complex logic)

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Reversing boat lift motor

You can use BBCodes to format your content.
Your account can't use Advanced BBCodes, they will be stripped before saving.

Your information: