[Resolved] Purpose of LS1-LS2 terminals

Home Forums Wireless Kits Support (KIT-1, KIT-2, TX134 etc) Purpose of LS1-LS2 terminals

This topic contains 4 replies, has 2 voices, and was last updated by   William 3 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #10524 Reply

    Don Kleinschnitz

    What is the function/purpose of the LS1 & LS2 blue terminals and a third terminal on the same block.

    #10526 Reply

    William
    Keymaster

    Hello Don,

    LS stands for limit switch, LS1 & LS2 controls relay 1 & 2 respectively, they share a common ground connection.

    The 3 blue terminals from up to down can be read as LS1 COM LS2.

    For example, when LS1 is connected to COM (by limit switch outside or other sensor) then relay 1 will be forced off, even the remote tells it to stay on.

    Hope it helps, thanks.

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

    #10532 Reply

    William
    Keymaster

    Hello Don,

    I will mark this topic as resolved due to no further response, please contact us if you still have questions, thanks.

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

    #13000 Reply

    Patrick Carr

    Once the relay is forced off with the Limit Switch, does it reset to N/O, such that the next button press (command) will actuate it again, or once the relay is forced off with Limit Switch, does the button need to be pressed once to reset it and again to latch it on?

    #13007 Reply

    William
    Keymaster

    It is a simple one.
    Once limit switch released, the relay will revert back to the state that it should be in (purely by remote control command), without limit switches.

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

Viewing 5 posts - 1 through 5 (of 5 total)
Reply To: Purpose of LS1-LS2 terminals

You can use BBCodes to format your content.
Your account can't use Advanced BBCodes, they will be stripped before saving.

Your information: