[Resolved] Kit 1 manual

This topic contains 3 replies, has 2 voices, and was last updated by   William 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #13120 Reply

    Lee Johnson

    I cannot find the kit 1 manual on the site. Where is it? I’m trying to use it for operating a commercial garage door opener. Thank you

    #13122 Reply

    William
    Keymaster

    Hi,
    It is available at http://docdro.id/eY12WkA
    There is only basic wiring on the manual.

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

    #13126 Reply

    Lee Johnson

    My garage door opener only has a three button (open, close & stop) on the wall now. Any recommended timer setting for this? I’m only interested in open and close. thanks,

    #13127 Reply

    William
    Keymaster

    Usually customer wire our relay output to your opener (or wall switch that eventually goes to opener unit).

    The relay on our unit only pulses, it is up to your main controller to handle the up/down logic.

    The wall unit is just a signal input terminal.

    Your wall switch, however, seems to be a mechanical switch that connect & disconnect circuit directly?

    If that is the case, please make sure the motor rating is less than 6A @14Vdc or our relay will damage quickly.

    And for this type, use a DC motor forward & reverse configuration, timer setting is not available.

    Thanks.

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

Viewing 4 posts - 1 through 4 (of 4 total)
Reply To: Kit 1 manual

You can use BBCodes to format your content.
Your account can't use Advanced BBCodes, they will be stripped before saving.

Your information: