[Resolved] Kit-1 202U with tx-134 remotes. Cannot program remotes with unit

Home Forums Wireless Kits Support (KIT-1, KIT-2, TX134 etc) Kit-1 202U with tx-134 remotes. Cannot program remotes with unit

This topic contains 3 replies, has 3 voices, and was last updated by  Mike C 1 month ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #12862 Reply

    Mike C

    Unit has power (red power light is on).
    Remotes have power (red light on remote lights with button press)

    When holding the switch in the unit to program remotes, the red light comes on, but when pressing a button on a remote to program, the unit light does not flash, nor does it light up after when I press the button I tried to program.

    #12863 Reply

    William
    Keymaster

    Understood.

    Sorry for the trouble, I see it might be a receiver module issue, that prevents receiver from decoding the RF signals.

    If tried multiple times (and rule out signal interference problem), then it might be a faulty receiver module.

    In this case, please mark it as defective, visit Amazon return center to initiate the return & get your full money back.

    Thanks and let me know if you have other questions.

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

    #12865 Reply

    Bryson79
    Participant

    Just a question for my curiosity. when you press the button on the remote does the red light on the remote flash or stay on constant as long as the button is held down. For the 202U it should stay on constant as long as the button is held down, If it flashes is is set to 402U mode and will need to be re set to the proper mode.

    #12867 Reply

    Mike C

    It stays on constantly as long as I hold the button.

Viewing 4 posts - 1 through 4 (of 4 total)
Reply To: Kit-1 202U with tx-134 remotes. Cannot program remotes with unit

You can use BBCodes to format your content.
Your account can't use Advanced BBCodes, they will be stripped before saving.

Your information: