[Resolved] Is there any examples or documentation on implementing the Virtual Channels 3&4

Home Forums Wireless Kits Support (KIT-1, KIT-2, TX134 etc) Is there any examples or documentation on implementing the Virtual Channels 3&4

This topic contains 1 reply, has 2 voices, and was last updated by   William 5 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #12998 Reply

    Brian Rese

    I am wanting to use the 2 virtual channels(ports) in the receiver to interface with an Arduino which would require a 0V or 5V output into an Arduino channel or other digital input device. I see that it is an active low sinking output, but not sure what I would need to do to interface it with other digital input devices. Are there any diagrams or examples that can be shared on how to do this? Or any tutorials on integrating the virtual channels? Any help would be greatly appreciated.

    Thank You,
    Brian

    #12999 Reply

    William
    Keymaster

    It is like below

    https://imgur.com/a/eCqggVA

    Share common ground between our receiver and your Arduino device.
    When relay 3 activates, the port is connected to GND, then it would be similar as you pressed button on the Breadboard in photo.

    Buy KIT-1 at Amazon.com here
    Want better range and security? check out KIT-2
    Need spare remotes for KIT-1 or KIT-2? see here

Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Is there any examples or documentation on implementing the Virtual Channels 3&4

You can use BBCodes to format your content.
Your account can't use Advanced BBCodes, they will be stripped before saving.

Your information: