Posted: one year ago Quote
Programming to an SMXI Receiver

Memorising a remote control

When the memorisation phase is activated, any transmitter correctly recognised within the reception
range of the radio is memorised. Consider this aspect with care and remove the aerial if necessary to reduce the capacity of the receiver.

The procedures for memorising the remote controls must be performed within a certain time limit, please read and understand the whole procedure before starting.

In order to carry out the following procedure, it is necessary to use the button located on the box of the radio receiver within your control panel, and the corresponding LED to the left of the button.

Model 1 Memorising - each button activates the corresponding output in the receiver

1. Press and hold down the receiver button for at least 3 seconds
2. Release the button when the Led lights up
3. Within 10 seconds press the 1st button on the transmitter to be memorised, holding it down for at least 2 seconds

N.B.: If the procedure was memorised correctly, the Led on the receiver will flash 3 times. If there are other transmitters to memorise, repeat step 3 within another 10 seconds The memorisation phase finishes if no new codes are received for 10 seconds.

Model 2 Memorising - each button can be associated with a particular output

1. Press and release the receiver button as many times as the number of the desired output (twice for output no. 2)
2. Make sure the Led flashes as many times as the number of the desired output (2 flashes for output no. 2)
3. Within 10 seconds press the desired button on the transmitter to be memorised, holding it down for at least 2 seconds.

N.B.: If the procedure was memorised correctly, the Led on the receiver will flash 3 times. If there are other transmitters to memorise, repeat step 3 within another 10 seconds The memorisation phase finishes if no new codes are received for 10 seconds.

Remote memorising

It is possible to enter a new transmitter in the receiver memory without using the keypad. A previously memorised and operational remote control must be available. The new transmitter will inherit the characteristics of the previously memorised one. Therefore, if the first transmitter is memorised in mode I, the new one will also be memorised in mode I and any of the buttons of the transmitter can be pressed. If the first transmitter is memorised in mode II the new one will also be memorised in mode II but the button activating the required output must be pressed on the first transmitter as must the button required to be memorised on the second. You need to read all the instructions in advance so you can perform the operations in sequence without interruptions. Now, with the two remote controls (the NEW one requiring code memorisation and the OLD one that is already memorised), position yourself within the operating range of the radio controls (within maximum range) and carry out the instructions listed in the table.

1. Press the button on the NEW transmitter for at least 5 seconds and then release
2. Press the button on the OLD transmitter 3 times slowly
3. Press the button on the NEW transmitter slowly and then release

N.B.: If there are other transmitters to memorise, repeat the above steps for each new transmitter.

Solidremote - Low Cost Nice Flor-S China Factory - Source from factory NOW